Catalog > Internet of Things (IOT) Related Products > DAGU Dagu Encoder Kit Encoder Kit Hall Effect Sensors DGU SIMPLE ENCODER KIT RS030 Simple Encoder Kit with 8pole Magnets + 2 Hall Effect Sensors 173.47 ZAR inc for 1 Each 0 in Stock Add Specifications, Prices & Availability may change without notice. Images are for illustration purposes only. E&OE Features The simple encoder kit from DAGU consists of two neodymium 8-pole magnets with rubber hubs and two hall-effect sensors terminated with 150mm (6inch) cable and 3 pin female servo headersThe magnets have 4 north poles and 4 south poles and are strong enough that the sensor can detect the poles from more than 3mm (1/8inch)This means that the sensors do not need to be precisely mounted to detect the polesThe rubber hubs will press fit over most small motor and drive shafts used in low power gearboxesA small screw may also be used to attach the magnets in some casesThe hall-effect sensors will work on voltages from 3V to 24V and include reverse polarity protectionThe open drain output, when fitted with an external pullup resistor will drive any logic circuit from 3V to 24V and can also drive a LED or any other small load less than 25mAThese sensors can plug directly into any DAGU, Arduino compatible controller and use the processors internal pullup resistors eliminating the need for any external components or wiring Specifications Supply voltage: 3V-24VSupply current: 4mA per sensorOutput voltage: 26V maximumOutput current: 25mA continuousOutput type: Open drainWiring :White wire: OutputRed wire: +3V to 24VBlack wire: Ground (0V) Downloads DAGU How to use a quadrature encoder PDF File 171.12 KB DAGU WILD THUMPER WITH QUADRATURE ENCODER PDF File 107.77 KB Datasheet DAGU SIMPLE ENCODER KIT PDF File 69.28 KB