8 Inputs to communicate separate alarm conditions
- Each input can be triggered to send an SMS to up to 16 Cellphone numbers
- The time delay before the input is triggered can be set for each input
- Separate messages can be configured for On and Off states of the input signal
- Messages to be send can be programmed by the user
- On or Off states can both be reported to predefined cellphone numbers.
- Reporting can be disabled for an input
- The states of the inputs can be requested from the unit by SMS
- Monitoring of the inputs can be controlled using different modes
- Inputs can act as counters
- Inputs can act as Run Hour meters
4 Analog Inputs
- Each analog input can perform a analog measurement and report 2 High alarmsand 2 low alarms per input.
- Time delay can be configured for each alarm
- Analog alarm levels can control relay outputs to enable analog control functionality.
- Analog changes can be logged to a server via GPRS communications.
8 Outputs to control any electrical device
- Outputs can be controlled by cellphone using SMS on, off or pulse
- Output controls can be scheduled
- The duration of the pulse can be programmed for each output
- Outputs can be set to follow the state of an input
- Output can be set to switch on when the unit is dialed
- Status of an output can be requested from the unit by SMS
- Analog Limits can control the switching of outputs
- Own text can be used to control outputs
Monitor AC power using the charger input
- AC power can be monitored by using the charger input.
- SMS can be send to up to 16 numbers when an power failure occur and when the power return
Monitor the battery status
- The battery status can be monitored by the system.
- SMS can be send to up to 16 numbers when the battery go faulty.
- The battery is monitored by disconnecting it from the main supply and to measure the battery voltage while connected to a load.
Remote Program Commands via SMS / GPRS * The setting of configuration parameters remotely by SMS or GPRS.
Remote Control Program Commands via SMS / GPRS
- The execution of Control Commands remotely by SMS or GPRS.
Scheduled Commands
- The execution of commands can be scheduled
SD Card Logger
- The system will log events configured to be logged
- Logged events will be time stamped from the Cell phones Date/Time
- Events can be downloaded into a comma delimited file for analysis
Monitor Mode
- Monitor mode is used to activate monitor functions
- Monitor Mode can be set by SMS or Monitor mode Inputs
LCD Add on
- Display Status information on LCD display
- Multiple pages on LCD Display
- Pages configurable to user requirements
Custom Status Message
- Custom status reply messages can be configured
Configuration tool to configure unit to user requirements
- All parameters can be set from configuration tool.
- Remote programming possible from the configuration tool
- Save and Load from files for backup